Installation Manual
© ip.access Ltd Page 2 of 12
COMPANY CONFIDENTIAL CENG0210_XB Hardware Installation -
nanoBTS.doc
The nanoBTS is intended for dry indoor applications only. If evidence
of condensation is present do not apply power to the nanoBTS.
The cabling to the nanoBTS and power supply is to run indoors only.
The nanoBTS must only be powered using a PSU supplied by
ip.access; the approved part is APC model PSU109 with UL file
number E231617.
PSUs supplied by ip.access must not be used for powering any other
equipment.
The external antenna ports are not covered by this products UL
approval.
1.3 Regulatory Information
For all regulatory information please see CENG0133 Ref{1}.
1.4 Unpacking
Unpack nanoBTS and check to see that the unit has not been damaged in transit. Any
damaged units should be returned to your supplier.
Figure 1 - Unpacking the nanoBTS