Installation Manual

© ip.access Ltd Page 10 of 12
COMPANY CONFIDENTIAL CENG0210_XB Hardware Installation -
nanoBTS.doc
2
Locking Spring
1
T
O
P
Figure 13 - Mounting the nanoBTS
When fixing to a ceiling or a sloping wall the same fixing process and clearances
should be observed as for fixing to a wall (at least 80mm from the bracket to the top
of wall and 120mm from the side of the bracket to a side wall). On a sloping surface
the top of the bracket MUST be uppermost. Once the unit has been attached to the
bracket the outer cover MUST be removed to expose the cooling vanes, as shown in
Figure 14 - Ceiling Mounted nanoBTS
Figure 14 - Ceiling Mounted nanoBTS
1.8.1 Mounting Multi-TRX nanoBTS
When the nanoBTS are to be installed in a Multi-TRX configuration, then each TRX
should be installed in a similar orientation but not closer than 30cm to each other.
A further specific constraint is that the TIB cables must be <1.5m and a 1.5mm
2
Earth
cable must also be connected between each TRX with a length not exceeding that of
the TIB cable.