User's Manual

nanoLTE AP Hardware Installation Introduction
NANO_INST_43311 v101_0.2 for N4G_1.1 © ip.access Limited 2016 Page 1
1 Introduction
The ip.access nanoLTE AP is an indoor Access Point for enterprise small cell applications.
This manual provides all the necessary information required for hardware installation of a
nanoLTE AP.
1.1 Overview
This manual is organised as follows:
• This introduction
• An overview of AP installation, including site requirements for all AP variants and
specific requirements for each AP model
• AP hardware installation by AP type:
• nanoLTE E40 AP
• Troubleshooting
• Regulatory warnings and safety information
1.2 Warnings and Regulatory Information
For all warnings and regulatory information, see section 5.
1.3 Related Information
1.4 Licenses and Copyright Notices
Portions of the AP are constructed from third-party software and open source code and
ip.access Ltd gratefully acknowledges the contributions that these libraries, technologies
and components have made to the product. Each of these is supplied under the terms of a
license agreement and these are either reproduced or referenced in [REF_43005], in line
with the stipulations of their authors.
1.5 Terminology
Common System terminology is defined in [REF_11105].
For additional terminology, see [21.905].
[GST_41050] nanoLTE System Planning (NANO_GST_41050)
[INST_43370] nanoLTE AP Pre-Provisioning and Configuration (NANO_INST_43370)
[OPM_43005] nanoLTE AP Operations (NANO_OPM_43005)
[REF_11105] System Glossary (NANO_REF_11105)
[REF_43005] nanoLTE AP Open Source Software (NANO_REF_43005)
[TRB_43005] nanoLTE AP Troubleshooting (NANO_TRB_43005)
[21.905] Vocabulary for 3GPP Specifications (3GPP TR 21.905)