User's Manual

nanoLTE AP Hardware Installation nanoLTE AP and PSU Regulatory Information
NANO_INST_43311 v101_0.2 for N4G_1.1 © ip.access Limited 2016 Page 20
5.2 Hardware Equivalence for 248 and 278 Product Variants
The 248 and 278 product variants have an identical hardware build for each set of
supported bands. Hence the hardware build is identical in each of these cases:
• 248J and 278J
• 248L and 278L
• 248M and 278M
The only difference between 248 and 278 variants is that internal fuses within the processor
are configured on the 278 variants in order to store unique security information, allowing the
product to boot up securely.
Note: To implement the added security, the software/firmware has been adjusted for the 278
variants. Product operation and in particular the RF operation of this variant is not altered in
any way. The RF Technology (LTE), frequencies and power level are identical between both
variants.
In respect of the 248M and 278M variants of the nanoLTE E40 AP, ip.access has reviewed
the Software Changes section of the FCC Permissive Changes Document dated 16th Oct
2015. It has been determined that the difference between these two product models can be
classed as a permissive change.
5.3 Regulatory Statements for nanoLTE E40 AP
5.3.1 EU Regulatory Compliance
The nanoLTE AP models 248J, 278J, 248L and 278L conform to the following regulatory
standards:
"Hereby, ip.access Ltd, declares that this nanoLTE 248J, 278J, 248L and 278L are in
compliance with the essential requirements and other relevant provisions of Directive
1999/5/EC."
A copy of regulatory compliance documentation may be obtained in writing from "IP Access
Ltd, Building 2020, Cambourne Business Park, Cambourne, Cambridge, CB23 6DW, UK".
Health (Art 3.1(a)): EN50385: 2002
Safety (Art 3.1(a)): EN60950-1: 2006 + A11:2009 + A1:20110+ A12:2011
EMC (Art 3.1(b)): EN 301 489-23 V1.5.1, EN 301 489-1 V1.9.2
Spectrum (Art 3.2): EN 301 908-14 V6.2.1
This product is intended for use in all
Member States of the European Union.