User's Manual

nanoLTE AP Hardware Installation Troubleshooting
NANO_INST_43311 v101_0.2 for N4G_1.1 © ip.access Limited 2016 Page 17
4.3.1 E40 Factory Reset
1) Use a thin rod to press and hold the reset button.
2) Keep the reset button pressed until the Service LED changes from blinking fast
(50ms on, 50ms off) to blinking slowly (50ms on, 200ms off).
The 4G Service LED blinks fast (50ms on, 50ms off) until the factory reset
commences, then it blinks slowly (50ms on, 200ms off). When the factory restore
process is complete, the LED extinguishes and the AP automatically reboots,
takes the fixed IP address for commissioning.
3) See the nanoLTE AP Troubleshooting manual [TRB_43005] for the full AP restart
sequence following a factory reset.