User's Manual

nanoLTE AP Hardware Installation Troubleshooting
NANO_INST_43311 v101_0.2 for N4G_1.1 © ip.access Limited 2016 Page 14
4.2 nanoLTE E40 AP LEDs
The following table shows the meaning of the status indicators under normal and fault
conditions.
Note: The two remaining LEDs are not currently used.
Note: The Ethernet port has standard indicator LEDs, showing when the network connection is up
and flashing for network activity.
Power
Off The nanoLTE AP is not switched on.
Green The nanoLTE AP is powered up normally.
Red There is a fault with the nanoLTE AP.
Service
Off The nanoLTE AP is not provisioned, it has no IP address. This
may be a temporary condition when the AP is switched on for the
first time, or after factory reset.
Green off, Red on Cell down, service not available and serious SW fault
Flashing green
(1800msec on,
200msec off), Red
off
Cell down, service not available
Green flashing(500
msec on, 500 msec
off), Red off
Cell locked, service not available
Green
flashing(50msec
on, 50msec off),
Red off
Nornal reboot, when reset button pressed for less than 5 secs
Green
flashing(50ms on,
200ms off), Red off
Factory reset, when reset button pressed for more than 5 secs