User's Manual

nanoLTE AP Hardware Installation nanoLTE E40 AP Hardware Installation
NANO_INST_43311 v101_0.2 for N4G_1.1 © ip.access Limited 2016 Page 11
3.4 Mount the E40 AP on a Wall
Note: The E40 AP should be installed in a position so that it is at least 2m away from the area
where handsets are normally used.
The E40 AP must be mounted vertically to ensure air circulation around the unit.
The location of each E40 AP should be shown on an installation floor plan produced at the
network planning stage. For example, it must take into account that all APs must be at least
2m from any mobile equipment. The network wiring must be complete before the E40 AP
can be installed and commissioned. The E40 AP should be placed on a wall at or above
head height.
1) Remove the wall bracket from the E40 AP. Lay the AP on a flat surface with the
wall bracket upwards. Slide the removal tool over the central guide groove over the
fin between the bracket and the body of the unit to disengage the locking spring,
then slide the bracket to separate it from the AP. The removal tool may be inserted
from the top or bottom of the AP.
2) Position the bracket on the wall with its flat surface against the wall and the clip
part towards the top. Ensure the bracket is level and sufficient clearance is
maintained to allow the AP to be fitted to the bracket. Allow at least 100mm from
the bracket to the top of wall, and 150mm from the side of the bracket to a side
wall.