User's Manual

nanoLTE AP Hardware Installation Installation Overview and Requirements
NANO_INST_43311 v101_0.2 for N4G_1.1 © ip.access Limited 2016 Page 6
2.3.2 E40 AP Physical Requirements
An E40 AP is installed by attaching its mounting plate to a wall or partition with screws, then
sliding the rear surface of the AP onto the mounting plate.
Pay attention to ensure that air can circulate freely around the unit. The unit must be
vertical.
It is recommended to install the AP with its front surface facing the area requiring cellular
coverage, unobstructed by walls or partitions that may cause significant RF attenuation.
2.3.3 Thermal Protection
The nanoLTE E40 AP may become warm during normal operation.
Ensure the AP is in a location where it will be at least 20cm away from personnel and any
items that may be heat sensitive.
2.3.4 E40 AP Backhaul (IP) Bandwidth Requirements
At maximum capacity and with IPsec in use, a nanoLTE E40 AP will require:
• Downlink: 100Mbps
• Uplink: 37.5Mbps
This will provide bandwidth for 16 users.
2.3.5 E40 AP Installation Tool Requirements
To mount the bracket onto the wall:
• 4 pan head screws, size No. 6 (approx 3.5mm (0.14in) in diameter), for the AP
bracket.
• Wall plugs if required.
• Suitable drills and screwdriver.
Dimensions and
weight
Height 202mm
Width 266mm
Depth 41mm
Approximate Weight 1.2 kg
Environmental Cooling Vents on the back at top and bottom
Operating Temperature 0°C to +45°C
Operating Humidity 10 to 70% non-condensing