User's Manual
Table Of Contents
- nanoLTE AP Pre-Provisioning and Configuration
- Table of Contents
- 1 Introduction
- 2 Pre-Provisioning Overview
- 3 Capturing Network Policies and AP Modes
- 4 AP-Unique Parameters
- 5 System Preparation for nanoLTE AP Provisioning
- 6 Template Preparation
- 7 AP Provisioning
- 8 How to Implement Policies
- 9 Installation Checks
nanoLTE AP Pre-Provisioning and Configuration Installation Checks
NANO_INST_43370 v101_0.4 for N4G_1.1 © ip.access Limited 2016 Page 66
5) When the scan is complete, view the results to verify there is some radio activity.
This assumes that the AP is in a location where it can detect neighbouring LTE
cells.
9.3 Ensure the AP is in Service
Once the AP has the latest software image, any additional configuration is complete and
any frequency correction has been applied, it is ready for service.
These steps ensure that all configuration changes are correctly applied to the nanoLTE AP.
1) Right-click the AP’s parent AP Info object and select Actions > Lock AP.
2) Right-click the AP’s parent AP Info object and select Actions > Unlock AP.
3) If the installation engineer is still on site, the engineer should make test calls to
verify the AP is providing service.