User's Manual

nanoLTE AP Pre-Provisioning and Configuration Installation Checks
NANO_INST_43370 v101_0.4 for N4G_1.1 © ip.access Limited 2016 Page 65
9.2 Configuration Audit
9.2.1 Final Attribute Changes and Checks
1) Login to the NOS Client with a user name that has Full Access to the required AP.
2) Use AP filtering to make the required AP visible in the object tree in the Explorer
Pane.
Note: For details on using AP filtering, see [OPM_43005].
3) Check any AP-specific configuration changes that may not have already been
applied by the Create Site Wizard or loading configuration files. In particular,
ensure the static neighbour lists are correctly configured. See [OPM_43005] for
information on neighbour list configuration.
4) Spot check any or all of the following packages to verify the parameters are set to
the correct values:
• Device.Services.FAPService{i}.CellConfig.LTE.RAN.RF
• Device.Services.FAPService.{i}.CellConfig.LTE.EPC
9.2.2 Network Listen and Frequency Correction
1) If not already logged in, login to the NOS Client with a user name that has Full
Access to the required AP.
2) Use AP filtering to make the required AP visible in the object tree in the Explorer
Pane.
Note: For details on using AP filtering, see [OPM_43005].
3) Select the AP object and select the Device.DeviceInfo. package and check that the
UpTime parameter is greater than 1200 (which is 20 minutes) before continuing.
This ensures the frequency crystal has had some time to warm up and achieve a
degree of thermal stability prior to checking if it needs any frequency correction.
4) To execute a Network Listen scan, right-click the AP Site (AP Info) object, then
select Action > Perform NWL Scan.