User's Manual
Table Of Contents
- nanoLTE AP Pre-Provisioning and Configuration
- Table of Contents
- 1 Introduction
- 2 Pre-Provisioning Overview
- 3 Capturing Network Policies and AP Modes
- 4 AP-Unique Parameters
- 5 System Preparation for nanoLTE AP Provisioning
- 6 Template Preparation
- 7 AP Provisioning
- 8 How to Implement Policies
- 9 Installation Checks
nanoLTE AP Pre-Provisioning and Configuration How to Implement Policies
NANO_INST_43370 v101_0.4 for N4G_1.1 © ip.access Limited 2016 Page 57
8 How to Implement Policies
The sections above describe a suggested set of mandatory parameters and templates to be
considered for AP provisioning. There are other patterns of behaviour that could usefully be
defined in templates for application to selected APs, but these are not usually fundamental
to deployment in the way the parameter groups above are.
The groups below could be created as separate overlay templates, or some elements could
be added to the Network Wide or AP Mode template if deemed important for a particular
deployment design.
The parameters below are all defined in the TR-069 AP CM Data Model Reference Manual
[REF_43150], with further information available in other manuals.
Note: For information on configuring the optional Long Range Extension (LRE) feature, see
[INST_43375].
The topics in this section are:
• 8.1 Access Control
• 8.2 Optional Network Listen Policies
• 8.3 Periodic Inform Interval
• 8.4 PM Reporting
• 8.5 DSCP Marking on the Backhaul
• 8.6 Diagnostics Settings
• 8.7 Mobility Parameter Optimisation
8.1 Access Control
The nanoLTE AP only uses Open Access.