User's Manual

nanoLTE AP Pre-Provisioning and Configuration AP Provisioning
NANO_INST_43370 v101_0.4 for N4G_1.1 © ip.access Limited 2016 Page 55
7.5.2 RF Parameters
1) Select the AP object.
2) Select FAPService.{i}.CellConfig.LTE.RAN.RF..
3) Ensure the following parameters are set correctly for this AP:
• EARFCNDL
• EARFCNUL
• FreqBandIndicator
• DLBandwidth
• ULBandwidth
• ReferenceSignalPower
•PhyCellID
• X_000295_PHICHResource
4) Click Commit to DB to save the parameters in the NOS database. The AP will pick
up the updated configuration when it connects to the NOS for the first time.
7.5.3 Other Mandatory Parameters
5) Select the Device.Time. package and ensure the LocalTimeZone is set correctly.
6) Select Device.Services.FAPService.{i}.CellConfig.LTE.RAN.PHY.PRACH. and
ensure RootSequenceIndex is set correctly. This needs to be different from
neighbour cells to prevent RACH collisions.
7) Select Device.Services.FAPService.{i}. CellConfig.LTE.EPC. and ensure TAC
is set correctly.
7.5.4 Other Parameters
8) Select Device.Services.FAPService.{i}.REM.LTE. and ensure
X_000295_MacroCellTxThreshold is set correctly.
9) Select Device.Services.FAPService.{i}.AccessMgmt.LTE. and ensure
HNBName is set correctly.
10) Select Device.Services.FAPService.{i}.CellConfig.LTE.EPC. and ensure that
the AllowedCipheringAlgorithmList and
AllowedIntegrityProtectionAlgorithmList are correct. That is, delete any
unwanted items from each list - there must be at least one item in each list.
Note: These parameters are not "per AP" parameters, but they must be checked
per AP if the network policy is to remove any entries from these lists. This
is because unwanted entries in these lists cannot be removed with a
template.