User's Manual
Table Of Contents
- nanoLTE AP Pre-Provisioning and Configuration
- Table of Contents
- 1 Introduction
- 2 Pre-Provisioning Overview
- 3 Capturing Network Policies and AP Modes
- 4 AP-Unique Parameters
- 5 System Preparation for nanoLTE AP Provisioning
- 6 Template Preparation
- 7 AP Provisioning
- 8 How to Implement Policies
- 9 Installation Checks
nanoLTE AP Pre-Provisioning and Configuration AP Provisioning
NANO_INST_43370 v101_0.4 for N4G_1.1 © ip.access Limited 2016 Page 51
7.3.6 Amend the Mandatory AP Parameters
24) The final page of the wizard has a selection of mandatory attributes:
Use this page to check the parameters that are not configured in the previous
pages of the wizard. Also, if these parameters have been set by a template as
recommended, ensure that the parameters are set are correct for this AP.
25) Select Device.Security. on the left. If X_000295_CRLServerBaseUrl is not set
from a template, enter the correct URL now.
26) Select Device.IPsec. on the left. This is enabled by default. If IPsec is not
required, uncheck the Enable check box.
27) Select FAPService.{i}.CellConfig.LTE.RAN.RF. on the left.
28) Ensure that FreqBandIndicator is set to the band of operation required for this AP.
29) Ensure that PhyCellID is set to a value that does not clash with any neighbour
cells.
Note: If the AP’s deployment location, and hence its neighbour cells, are not yet
known, this can be left at any value until the AP is deployed.
30) Drill down into the DLBandwidth parameter and ensure it is set to the correct
value in resource blocks, which is one of:
Required Bandwidth Enter Value in Resource Blocks
5MHz 25
10MHz 50 (default value)
15MHz 75
20MHz 100