User's Manual
Table Of Contents
- nanoLTE AP Pre-Provisioning and Configuration
- Table of Contents
- 1 Introduction
- 2 Pre-Provisioning Overview
- 3 Capturing Network Policies and AP Modes
- 4 AP-Unique Parameters
- 5 System Preparation for nanoLTE AP Provisioning
- 6 Template Preparation
- 7 AP Provisioning
- 8 How to Implement Policies
- 9 Installation Checks
nanoLTE AP Pre-Provisioning and Configuration AP Provisioning
NANO_INST_43370 v101_0.4 for N4G_1.1 © ip.access Limited 2016 Page 47
7.3.2 Select an AP Template
This is optional as, instead, it is recommended to automatically apply templates by
associating them with the Product Class. However, this page can be used to apply one
template that embodies, for example, a regional policy or AP operational use case.
Alternatively, any number of templates can be applied to the AP on completion of the
Create Site Wizard.
7) If View Available Templates was checked on the first page of the wizard, the
Template Selection page will appear:
Use this page to load a template for the AP. Typically the template can contain a
reference configuration for the AP according to the AP’s intended location and/or
usage.
For information on setting up templates for AP provisioning, see [INST_43380].
8) Click the required template in the list, then click Next>>.
Note: If a template is not required after all, click <<Previous, uncheck View
Available Templates then click Next>> again.