User's Manual

nanoLTE AP Pre-Provisioning and Configuration System Preparation for nanoLTE AP Provisioning
NANO_INST_43370 v101_0.4 for N4G_1.1 © ip.access Limited 2016 Page 39
5.8 Check the APs Object
Ensure the APs object is configured according to the required naming policy. See section
3.3 for information about naming policies.
5.8.1 Automate the Job IDs
This is only necessary if changes are required to the way that Job IDs are automatically
generated for APs. By default, Generate AP Job ID is false (unchecked) and Append
Equipment ID to Job ID is true (checked).
1) Select the Root > APs object.
2) Select the Job ID Construction Package.
3) Verify that the Generate AP Job ID and Append Equipment ID to Job ID
attributes are set correctly.
4) Click Apply to save any changes.
5.8.2 Check if AP Management by Group is Enabled
By default, all nanoLTE APs can be managed by NOS Client users. If preferred, manage
APs according to AP Group membership, and use this check to verify that this policy has
been enabled.
Note: If the NOS also manages nano3G APs, any changes to this policy will affect the nano3G
APs as well.
1) In the Root > APs object, select the User AP Groups Filter Package.
2) If AP management by AP Group is required, verify that Filter By User AP Groups
is checked.
3) If it is not checked, but it should be, a NOS Client user with user management
rights must change this via the Manage Users screen. See [OPM_14015] for
details.