User's Manual

nanoLTE AP Pre-Provisioning and Configuration System Preparation for nanoLTE AP Provisioning
NANO_INST_43370 v101_0.4 for N4G_1.1 © ip.access Limited 2016 Page 37
5.7 Check the LTE APs Object
Only one LTE APs object is required, which must be created before provisioning the first
nanoLTE AP. For a new system installation, verify that this object exists and, if needed,
create the object.
5.7.1 Verify the LTE APs Object Exists
1) To check if the LTE APs object already exists, look for it under the Root > APs
object. If it is present, no further action is required in this respect.
2) If the LTE APs object does not yet exist, right-click the APs object and select
Create > Child Object.
3) In the wizard, select the LTE APs object in the drop-down list:
Note: Do not change the Object Name. It is recommended to leave this object
with the default name of "LTE APs".
4) Click Next>> twice, then click Finish (that is, there is no need to make any other
edits in the Create Child Object Wizard). The new LTE APs object will appear
below the APs object.
5.7.2 Configure the LTE APs Object
1) Select the LTE APs object, then select its LTE APs Package:
2) Inspect the Default Associate TR-069 AP Service and Default Security Gateway
attributes to see if they are blank or not. For example:
As can be seen in this case, the new object is not yet associated with a TR-069 AP
Service or a default Security Gateway. If they are not blank, no further action is
required for configuring the LTE AP object, so skip to the next section.