User's Manual

nanoLTE AP Pre-Provisioning and Configuration System Preparation for nanoLTE AP Provisioning
NANO_INST_43370 v101_0.4 for N4G_1.1 © ip.access Limited 2016 Page 36
5.6 Create an AP Product Class
This is only required if there is no suitable Product Class.
1) Under the NOS object, right-click the Product Classes object and select Create >
Child Object.
2) Only one type of Product Class object can be created, so click Next.
Note: If a Template has been created for any Product Class object, a Template
Selection screen will appear. If it is not necessary to use a template, click
Next without selecting any template names.
3) In the Configure Product Class page, set the attributes values as follows:
• Class Type:
Select AP_TR069.
• Associated Object Class:
This will also set Target Object Class. This must match the version of
software (.sdp file) in the associated AP SW Version object. For N4G_1.1
releases, select the Associated Object Class according to the software
version as follows:
Note: Details of the Data Model for the AP Class can be found in the version of
[REF_43150] included in the corresponding system release.
• Object Name:
Enter a useful name to identify this object class. This can be any text, but
should reflect the usage of this Product Class.
• AP Software Version:
Select the name of the required AP SW Version object, as created
previously.
Note: Only set the Associated Object Class to the class noted above as other
classes will not match any AP software in N4G_1.1 System Releases.
4) Click Finish. The wizard will close and the new Product Class object is added.
This can now be referenced when using the Create Site wizard to pre-provision an
AP.
5) Create additional Product Classes as determined by nanoLTE AP hardware
variants and/or use cases.
6) If templates have already been created, associate one or more AP templates with
the Product Class. To do this, go to its Product Class Package, drill down to the AP
Template Object List, click the + button to add a new instance, then click the Select
button to choose a template to associate.
Note: A template used by a Product Class must not have any AP specific
parameters as this will cause attempts to use the Product Class to fail.
See section 6.5 for more information.
AP Software Version Associated Object Class
122.0 or later lte11Tr069_004