User's Manual

nanoLTE AP Pre-Provisioning and Configuration System Preparation for nanoLTE AP Provisioning
NANO_INST_43370 v101_0.4 for N4G_1.1 © ip.access Limited 2016 Page 35
5.5 Create an AP SW Version Object
This is only required if there is no suitable AP SW Version object.
1) Under the NOS object, right-click the AP SW Versions object and select Create >
Child Object.
2) Only one type of AP SW Version object can be created, so click Next.
Note: If a Template has been created for any AP SW Version object, a Template
Selection screen will appear. If it is not necessary to use a template, click
Next without selecting any template names.
3) In the Configure AP Software Version page, set the attributes values as follows:
• Object Name: A name that identifies this software version.
• SW Version: The formal software version as provided in the Release Notes
for that AP software release. For example: 123.0_signed.
• Software Product Number and Variant: This is a three digit code followed by
the letter K, so this will be one of:
• Software Image Download URL: The URL an AP can use to locate the SDP
file on the NOS server running the Software Download Service. The SDP file
name must match the specified software version and AP variant. Enter a
URL of the form:
http://<server>/download/sw/<file>
Where: <server> is the IP address or FQDN of the NOS server hosting the
Software Download Service, and <file> is the relevant .sdp file name. The file
name must contain the SW Version and Software Product Number and
Variant. This is validated by the wizard.
4) Click Next. The wizard will validate the entries, then close and the new AP SW
Version object is added.
AP Type Enter Value
nanoLTE E40 AP (278 hardware) 279K