User's Manual

nanoLTE AP Pre-Provisioning and Configuration System Preparation for nanoLTE AP Provisioning
NANO_INST_43370 v101_0.4 for N4G_1.1 © ip.access Limited 2016 Page 31
5.2 MME Pools
There must be at least one MME Pool with at least one MME. If they have not yet been
created, create them before using the LTE AP Create Site Wizard.
5.2.1 Create an MME Pool
1) Right-click the Root > MME Pools object and select Create > Child Object, then
click Next twice to get to the Set Mandatory Attributes page.
2) Optionally change the Object Name to allow easy identification of the MME Pool
referenced by this MME Pool object.
3) Select the MME Pool Package and enter the MME Group Id.
4) Drill down into the PLMN Id List and add at least one PLMN Id (MMC and MNC
are entered separately).
5) Drill down into the TACList and add at least one TAC.
Note: Additional PLMN IDs and TACs can be added to the MME Pool at any
time after the object is created.
6) Click Finish.
7) Create additional MME Pool objects as needed.
5.2.2 Create an MME
1) Right-click an MME Pool and select Create > Child Object, then click Next twice
to get to the Set Mandatory Attributes page.
2) Optionally change the Object Name to allow easy identification of the MME
referenced by this MME object.
3) Select the MME Package.
4) Enter the MME Code used by the MME.
5) Enter the MME Address (IP address or FQDN) that APs must use to connect to
this MME.
6) Click Finish.
7) If required, add more MMEs to the MME Pool.