User's Manual

nanoLTE AP Pre-Provisioning and Configuration AP-Unique Parameters
NANO_INST_43370 v101_0.4 for N4G_1.1 © ip.access Limited 2016 Page 28
4.2 Network Names
Device.Services.FAPService.{
i}.DNPrefix
This attribute defines the DN
(Distinguished Name) prefix that is
included in PM reports generated by
the AP in order to uniquely identify the
object generating the report. Hence this
allows generation of the full
Distinguished Name of the reporting
AP, which only knows the local part.
This is configured
automatically during
provisioning to ensure that
PM reports delivered to the
NOS are associated with
the AP. This can be
changed afterwards if an
alternative policy is
required for PM reporting.
MIB/Data Model Name Description Comment
MIB/Data Model Name Description Comment
Device.Services.FAPService.{
i}.CellConfig.LTE.RAN.Comm
on.CellIdentity
Cell Identity.
This is a concatenation of the 12-bit
RNC-ID and 16-bit on-air Cell ID
Device.Services.FAPService.{
i}.CellConfig.LTE.EPC.TAC
Tracking Area Code (TAC). This identifies the tracking
area that the nanoLTE AP
belongs to.
Device.Services.FAPService.{
i}.CellConfig.LTE.RAN.RF.Ph
yCellID
A physical cell ID in the range 0 to 503.
This can be a comma separated list of
candidate physical cell IDs. However,
as the nanoLTE AP does not yet
support self configuration, only the first
entry will be used.
Modifying the value of this parameter
triggers an AP re-boot on termination of
the TR-069 session.
Physical Cell ID that
determines the PSS
(Primary Synchronisation
Signal) and SSS
(Secondary
Synchronisation Signal)
used by the cell. This must
be different from any of the
nanoLTE AP’s neighbour
cells.