User's Manual

nanoLTE AP Pre-Provisioning and Configuration Capturing Network Policies and AP Modes
NANO_INST_43370 v101_0.4 for N4G_1.1 © ip.access Limited 2016 Page 24
3.8.2 3G REM Configuration (Network Listen)
Parameters for Network Listen (NWL) scans of 3G neighbour cells. If all nanoLTE APs
should have the same NWL configuration, include these parameters in the network-wide
Global Template.
Note: “Radio Environment Measurement” (REM) is the LTE standards terminology for Network
Listen (NWL).
MIB/Data Model Name Description Comment
FAPService.{i}.REM.UMTS.WC
DMA.InServiceHandling
AP REM behaviour with respect
to ongoing active connections.
The default is Immediate.
Immediate causes the AP to
start the REM, regardless of
active connections. Optionally
set this to Delayed, which waits
until no CS bearers or PS
bearers of streaming or higher
QoS class are assigned.
FAPService.{i}.REM.UMTS.WC
DMA.ScanPeriodically
Enable Periodic Radio
Environment Measurement on
3G bands.
Defaults to True for periodic
scans. Change this to False if
periodic scans of 3G neighbours
are not required.
FAPService.{i}.REM.UMTS.WC
DMA.PeriodicInterval
When parameter
ScanPeriodically is true, this
value indicates the interval in
seconds which REM is
performed while the AP service
is enabled.
Example value: 31536000 (one
year)
FAPService.{i}.REM.UMTS.WC
DMA.PeriodicTime
An absolute time reference in
UTC to determine when the AP
will initiate the periodic REM.
Each REM MUST occur at (or
as soon as possible after) this
reference time plus or minus an
integer multiple of the parameter
PeriodicInterval.
Example value:
0001-01-01T00:00:002
FAPService.{i}.REM.UMTS.WC
DMA.REMPLMNList
Comma-separated list. Each
item is a PLMN ID to measure.
PLMN ID consists of Mobile
Country Code (MCC) and
Mobile Network Code (MNC).
If empty, then no specific PLMN
ID is provided, meaning that the
AP is required to scan all
available PLMN IDs.
PLMNs scanned by Network
Listen. Likely to be a
network-wide base set.
It is recommended to set this
with a template, as in
[INST_43380].
FAPService.{i}.REM.UMTS.WC
DMA.REMBandList.
Comma-separated list. Each
item is a 3G Band to measure.
If empty then no specific 3G
band is provided, meaning that
the AP scans all available
bands.
The order of the band indicator
has no significance.
If bands are specified on a
network-wide basis, set this with
a template, as in [INST_43380].