User's Manual

nanoLTE AP Pre-Provisioning and Configuration Capturing Network Policies and AP Modes
NANO_INST_43370 v101_0.4 for N4G_1.1 © ip.access Limited 2016 Page 23
FAPService.{i}.REM.LTE.Scan
OnBoot
Enables or disables Radio
Environment Measurement
during the FAP start up. This is
False by default.
False is the recommended
setting for enterprise APs.
FAPService.{i}.REM.LTE.ScanP
eriodically
Enable Periodic Radio
Environment Measurement on
LTE EUTRAN bands.
Defaults to True for periodic
scans. Change this to False if
periodic scans are not required.
FAPService.{i}.REM.LTE.
PeriodicInterval
When parameter
ScanPeriodically is true, this
value indicates the interval in
seconds which REM is
performed while the AP service
is enabled.
Example value: 31536000 (one
year)
FAPService.{i}.REM.LTE.
PeriodicTime
An absolute time reference in
UTC to determine when the AP
will initiate the periodic REM.
Each REM MUST occur at (or
as soon as possible after) this
reference time plus or minus an
integer multiple of the parameter
PeriodicInterval.
Example value:
0001-01-01T00:00:002
FAPService.{i}.REM.LTE.REMP
LMNList
Comma-separated list. Each
item is a PLMN ID to measure.
PLMN ID consists of Mobile
Country Code (MCC) and
Mobile Network Code (MNC).
If empty, then no specific PLMN
ID is provided, meaning that the
AP scans all available PLMN
IDs.
PLMNs scanned by Network
Listen. Likely to be a
network-wide base set.
It is recommended to set this
with a template, as in
[INST_43380].
FAPService.{i}.REM.LTE.REMB
andList.
Comma-separated list. Each
item is an LTE Band to
measure.
If empty then no specific LTE
band is provided, meaning that
the AP scans all available
bands.
The order of the band indicator
has no significance.
Leave empty to scan all bands
(within hardware capability).
If bands are specified on a
network-wide basis, set this with
a template, as in [INST_43380].
FAPService.{i}.REM.EUTRACar
rierARFCNDLList
Comma-separated list. Each
entry is a EUTRA ARFCN in the
DL direction to measure.
If empty, then no specific
EUTRA ARFCN is provided,
meaning that the AP is required
to scan all ARFCNs that it is
aware of.
Leave empty to scan all
EARFCNs. However, it is
recommended to specify
frequencies to scan, as this will
reduce scan time.
If DL ARFCNs are specified on a
network-wide basis, set this with
a template, as in [INST_43380].
MIB/Data Model Name Description Comment