User's Manual

nanoLTE AP Pre-Provisioning and Configuration Capturing Network Policies and AP Modes
NANO_INST_43370 v101_0.4 for N4G_1.1 © ip.access Limited 2016 Page 19
3.6 Parameters Shared by a Group of APs
These parameters can be set with a use case Group Template, as in [INST_43380].
FAPService.{i}.CellConfig.L
TE.RAN.RRCTimers.X_000
295_TRRCReestablishment
When a nanoLTE
AP detects a local
RL failure it waits for
the UE to send
RRCReestablishme
ntRequest. This
parameter defines
how long the AP
waits for a UE to
send this message.
10000
(Default is 3000)
Increase the time to allow
UEs more time to reconnect.
Parameter Description Recommended
Value
Comment
Parameter Description Comment
Device.Services.FAPService.{i}.
CellConfig.LTE.EPC.TAC
TAC. This depends on the policy for
Tracking Area Code for
nanoLTE APs.
Device.Time.X_000295_NTPFr
equencyDisciplineEnabled
NTP frequency discipline
enabled. Defaults to False.
Not currently supported.
Device.Services.FAPService.{i}.
AccessMgmt.LTE.AccessMode
Access Mode. Defaults to Open. Only Open access is currently
supported.
Device.Services.FAPService.{i}.
Capabilities.LTE.DuplexMode
Duplexing Mode. Defaults to
FDD.
Only FDD is supported.
Device.Services.FAPService.{i}.
CellConfig.LTE.RAN.PHY.PUS
CH.Enable64QAM
Enable 64 QAM. Defaults to
False.
No support for 64QAM for
PUSCH (i.e UL).
Device.Services.FAPService.{i}.
REM.LTE.X_000295_MacroCell
TxThreshold
Macro Cell Tx Threshold. The
minimum value of Reference
signal power, transmitted in
SIB2 required for an LTE cell to
be considered as a macro cell.
Cells with reference signal
power values below this level
are considered femto cells and
are excluded from frequency
synchronisation. This is an
integer value: 0-1100
representing (-60 to +50 dBm) in
steps of 0.1 dBm. The default is
100, which equates to -50dBm.
If any APs will not use the
default, typically configure this
on a use case basis in an
appropriate use case template.