User's Manual

nanoLTE AP Pre-Provisioning and Configuration Capturing Network Policies and AP Modes
NANO_INST_43370 v101_0.4 for N4G_1.1 © ip.access Limited 2016 Page 18
3.5.5 Network Wide Policies
3.5.6 MME
3.5.7 Miscellaneous Parameters
Include these parameters in the Global Template so that all new APs are given the
recommended values shown in the following table:
Parameter Description Comment
Device.Services.FAPService.{i}.
CellConfig.LTE.EPC.AllowedCip
heringAlgorithmList
A list of allowed Ciphering
Algorithms. By default, all are
allowed: EEA0, 128-EEA1 and
128-EEA2. EEA0 means no
ciphering.
Remove unwanted items
according to the network policy.
This can be done with a global
template.
Device.Services.FAPService.{i}.
CellConfig.LTE.EPC.AllowedInt
egrityProtectionAlgorithmList
A list of allowed Integrity
Algorithms. By default, all are
allowed: 128-EIA1, 128-EIA2.
Remove unwanted items
according to the network policy.
This can be done with a global
template.
Parameter Description Comment
Device.Services.FAPService.{i}.
FAPControl.LTE.Gateway.S1Si
gLinkServerList
Femto LTE AP S1 Interface end
points.
May be set in a global template
if all APs will use the same MME
or set of MMEs. For regional use
cases, this is a likely candidate
for any regional templates.
Parameter Description Recommended
Value
Comment
FAPService.{i}.CellConfig.L
TE.RAN.PHY.ULPowerCont
rol.X_000295_Accumulation
Enabled
This parameter
controls whether
accumulation is
enabled or disabled
for PUSCH power
control.
False
(Default is True)
Setting this to False limits
the range of variation in
power of UEs using PUSCH.
This provides greater RL
stability when there are
multiple UEs connected to a
nanoLTE AP, compared to
setting the parameter to
True.
Note: Optionally, this
parameter can be set
to True for testing with
a single UE.