User's Manual

nanoLTE AP Pre-Provisioning and Configuration Capturing Network Policies and AP Modes
NANO_INST_43370 v101_0.4 for N4G_1.1 © ip.access Limited 2016 Page 16
3.5.2 Security Resources
3.5.3 NTP Servers
These are the operator’s own NTP servers, which should be the same for all APs. Hence it
is recommended to set these with a template associated with the Product Class, as in
[INST_43380].
Parameter Description Comment
Device.Services.FAPService.{i}.
FAPControl.LTE.Gateway.SecG
WServer1
secGwServer1. The first
SecGW that a nanoLTE AP
attempts to establish a
connection with.
This should be the same
Security Gateway as the default
Security Gateway address
supplied in the DOCP.
Device.Services.FAPService.{i}.
FAPControl.LTE.Gateway.SecG
WServer2
secGwServer2. The second
SecGW that a nanoLTE AP
attempts to establish a
connection with.
Not needed in most cases, but it
depends on the deployment.
Device.Services.FAPService.{i}.
FAPControl.LTE.Gateway.SecG
WServer3
secGwServer3. The third
SecGW that a nanoLTE AP
attempts to establish a
connection with.
Not needed in most cases, but it
depends on the deployment.
Device.IPsec.X_000295_Config
uredRemoteTrafficSelectors
Configured Remote end Traffic
Selectors
When using an ACME SecGW,
this must be left at default.
Configure this when using other
SecGW types.
Device.Security.X_000295_CRL
ServerBaseUrl
CRL server Base URL. If Mirror
CRL Server is reached via
Tunnel, CRLServerBaseUrl
should be set by the NOS after
connection. If the Mirror CRL
Server address is Public, this
CRLServerBaseUrl should be
part of AP commissioning data
(that is, the DOCP).
Should be the same for all APs.
This may be the same as the
CRL Mirror server in the DOCP.
Parameter Description Comment
Device.Time.NTPServer1 Public NTP Server address 1.
Public IP address or FQDN (the
FQDN must resolve to a single
address).
Should be the same for all APs.
Device.Time.NTPServer2 Public NTP Server address 2. Should be the same for all APs.
Device.Time.NTPServer3 Public NTP Server address 3. Should be the same for all APs.
Device.Time.NTPServer4 Public NTP Server address 4. Should be the same for all APs.