User's Manual

nanoLTE AP Pre-Provisioning and Configuration Capturing Network Policies and AP Modes
NANO_INST_43370 v101_0.4 for N4G_1.1 © ip.access Limited 2016 Page 14
3.4 Network-Wide AP Commissioning Parameters
The AP needs the following parameters to reach the NOS so that the AP can be
provisioned:
These read-only parameters are supplied to each AP in the DOCP, and are included in the
CIQ for reference. The AP has read-write equivalents of these parameters. In most
scenarios, set most the read-write equivalents to the same values as those supplied in the
DOCP.
The DOCP parameters must be agreed with ip.access in advance of placing any orders for
APs. A set of DOCP parameters is given a unique ID, the DOCP_Id, The DOCP_Id must be
specified at the time of ordering nanoLTE APs, so that the AP Equipment IDs (EIDs) can be
linked to the DOCP_Id, which in turn ensures that the AP is provided with the correct DOCP
parameters by the Redirector. For more information about how this is used by the
Redirection System to aid AP deployment, see [GST_14700].
Parameter Description Comment
Device.Time.X_000295_Default
NTPServer
Default NTP Server address Supplied to each AP in the
DOCP.
Device.IPsec.X_000295_Defaul
tIPsecEnable
IPsec Enable Supplied to each AP in the
DOCP.
Device.IPsec.X_000295_Defaul
tRemoteTrafficSelectors
AP Tunnel IP Address Pool
(IPSec traffic selectors)
Supplied to each AP in the
DOCP.
Device.Services.FAPService.{i}.
FAPControl.LTE.Gateway.X_00
0295_DefaultSecGWServer
Default Security Gateway
address
Supplied to each AP in the
DOCP.
Device.Security.X_000295_Def
aultCRLServerBaseUrl
Primary Mirror CRL Server Base
URL
Supplied to each AP in the
DOCP.
Device.ManagementServer.X_0
00295_DefaultMgmtServerURL
Management Server (NOS)
URL
Supplied to each AP in the
DOCP.