User's Guide
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 2.1 Installation Tasks
- 2.2 Requirements for All nano3G APs
- 2.2.1 General Requirements
- 2.2.2 nano3G AP Cooling
- 2.2.3 Information Required for Pre-Provisioning
- 2.2.4 Parameters for Enterprise Deployments
- 2.2.5 Parameters for Residential Deployments
- 2.2.6 Access Control
- 2.2.7 Closed Access with CSG Parameter Broadcast
- 2.2.8 Closed Access in Legacy Mode
- 2.2.9 Pre-Prepared Configurations - Optional
- 2.2.10 Information Required for Commissioning
- 2.2.11 Other Items for Commissioning
- 2.3 nano3G S8 AP Site Requirements
- 2.4 nano3G S16 AP Site Requirements
- 2.5 nano3G E8 AP and nano3G E16 AP Site Requirements
- 3 Pre-Provisioning a nano3G AP
- 4 Configuration File Preparation
- 5 Commission a nano3G AP
- 6 nano3G AP Hardware Installation
- 7 Finalize Installation
- 8 Troubleshooting
- 9 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual Commission a nano3G AP
N3G_INST_300 v292_1.0 for N3G_2.92 © ip.access Limited 2012 Page 50
9) There is no default gateway, so ensure the default gateway address is cleared.
10) Click OK to close and save the changes in each of the two dialogues. Also close
the Control Panel.
5.2 Start Up the AP
5.2.1 Start up a nano3G S8 AP
1) To power up an S8 AP or S16 AP, either.
• Use the power supply provided with the AP
or
• Connect a POE source to the splitter unit, then connect the short power
cable from the POE Splitter unit to the DC input on the AP
Note: The AP may have been provided with only one of these options.
2) Connect the commissioning terminal directly to the AP with an Ethernet cable.
5.2.2 Start up a nano3G E8 AP or E16 AP
1) To power up a nano3G E8 AP or E16 AP, typically do one of the following:
• Connect a cable to carry POE+ from the injector to the LAN1 port on the AP,
then plug the POE+ injector into the mains
or
• Connect the optional power supply for the AP to the AP’s 12V DC input
2) To establish an Ethernet connection between an E8 AP or E16 AP and the
commissioning terminal, do one of the following according to how the AP has been
powered up:
• If using POE+ to power the AP, connect the Ethernet cable from the
commissioning terminal to the LAN input on the POE+ injector unit
or
• If not using POE+, connect the Ethernet cable from the commissioning
terminal directly to the LAN1 port on the AP