User's Guide
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 2.1 Installation Tasks
- 2.2 Requirements for All nano3G APs
- 2.2.1 General Requirements
- 2.2.2 nano3G AP Cooling
- 2.2.3 Information Required for Pre-Provisioning
- 2.2.4 Parameters for Enterprise Deployments
- 2.2.5 Parameters for Residential Deployments
- 2.2.6 Access Control
- 2.2.7 Closed Access with CSG Parameter Broadcast
- 2.2.8 Closed Access in Legacy Mode
- 2.2.9 Pre-Prepared Configurations - Optional
- 2.2.10 Information Required for Commissioning
- 2.2.11 Other Items for Commissioning
- 2.3 nano3G S8 AP Site Requirements
- 2.4 nano3G S16 AP Site Requirements
- 2.5 nano3G E8 AP and nano3G E16 AP Site Requirements
- 3 Pre-Provisioning a nano3G AP
- 4 Configuration File Preparation
- 5 Commission a nano3G AP
- 6 nano3G AP Hardware Installation
- 7 Finalize Installation
- 8 Troubleshooting
- 9 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual Pre-Provisioning a nano3G AP
N3G_INST_300 v292_1.0 for N3G_2.92 © ip.access Limited 2012 Page 37
3.2.7 Select NTP Servers
2) The page for selecting NTP servers will appear:
If an existing AP, template or file was chosen, the NTP servers may have been
automatically selected from one of these sources. Any changes on this page of the
wizard will override settings from an existing AP, template or file.
3) Click the drop-down lists to choose up to four NTP servers for the AP. The
available NTP servers are defined under Root > NOS > NTP Servers. At least one
NTP server must be selected.
4) Click Next.
3.2.8 Modify NAS and Network Listen Settings
5) The page for NAS and Network Listen details will appear:
The initial values on this page of the wizard are selected as follows:
• MCC and MNC: These are copied from the target AC. That is, the AC
associated with the parent AC Detail object. The RNC-Id is also copied, but
this is not shown in the wizard.