User's Guide
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 2.1 Installation Tasks
- 2.2 Requirements for All nano3G APs
- 2.2.1 General Requirements
- 2.2.2 nano3G AP Cooling
- 2.2.3 Information Required for Pre-Provisioning
- 2.2.4 Parameters for Enterprise Deployments
- 2.2.5 Parameters for Residential Deployments
- 2.2.6 Access Control
- 2.2.7 Closed Access with CSG Parameter Broadcast
- 2.2.8 Closed Access in Legacy Mode
- 2.2.9 Pre-Prepared Configurations - Optional
- 2.2.10 Information Required for Commissioning
- 2.2.11 Other Items for Commissioning
- 2.3 nano3G S8 AP Site Requirements
- 2.4 nano3G S16 AP Site Requirements
- 2.5 nano3G E8 AP and nano3G E16 AP Site Requirements
- 3 Pre-Provisioning a nano3G AP
- 4 Configuration File Preparation
- 5 Commission a nano3G AP
- 6 nano3G AP Hardware Installation
- 7 Finalize Installation
- 8 Troubleshooting
- 9 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual Installation Overview and Requirements
N3G_INST_300 v292_1.0 for N3G_2.92 © ip.access Limited 2012 Page 27
2.4.3 nano3G S16 AP IP Bandwidth Requirements
At maximum capacity, a nano3G S16 AP will require:
• Downlink: 17Mbps
• Uplink: 1.9Mbps
This will deliver up to 16 voice calls and HSDPA services up to 14.4 Mbps.
Note: If the available bandwidth on site does not meet the requirements see the Troubleshooting
section 8 N User Configuration.
2.4.4 nano3G S16 AP Sundry Installation Equipment
To mount the POE splitter or the nano3G S16 AP onto the wall:
• 2 self tapping pan head screws, size No. 6 (approx 3.5mm (0.14in) in diameter)
• Wall plugs if required
• Suitable drills and screwdriver
Note: If the available bandwidth on site does not meet the requirements see the Troubleshooting
section 8 N User Configuration.