User's Guide
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 2.1 Installation Tasks
- 2.2 Requirements for All nano3G APs
- 2.2.1 General Requirements
- 2.2.2 nano3G AP Cooling
- 2.2.3 Information Required for Pre-Provisioning
- 2.2.4 Parameters for Enterprise Deployments
- 2.2.5 Parameters for Residential Deployments
- 2.2.6 Access Control
- 2.2.7 Closed Access with CSG Parameter Broadcast
- 2.2.8 Closed Access in Legacy Mode
- 2.2.9 Pre-Prepared Configurations - Optional
- 2.2.10 Information Required for Commissioning
- 2.2.11 Other Items for Commissioning
- 2.3 nano3G S8 AP Site Requirements
- 2.4 nano3G S16 AP Site Requirements
- 2.5 nano3G E8 AP and nano3G E16 AP Site Requirements
- 3 Pre-Provisioning a nano3G AP
- 4 Configuration File Preparation
- 5 Commission a nano3G AP
- 6 nano3G AP Hardware Installation
- 7 Finalize Installation
- 8 Troubleshooting
- 9 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual Installation Overview and Requirements
N3G_INST_300 v292_1.0 for N3G_2.92 © ip.access Limited 2012 Page 8
2.2.4 Parameters for Enterprise Deployments
Minimum Configuration - Enterprise Deployments
The minimum set of configuration data for the AP is:
Parameter Notes
HNB C-Id (hnbCId) This is the unique ID of this AP on the serving nano3G AC. The
term HNB is used in 3GPP in reference to small cells. The HNB
C-Id is used in the Register Request message to uniquely identify
the AP within the AC. The value is also combined with the RNC-ID
to give the 28 bit UC-Id (also known as TR-196 CellID) that is used
on-air in SIB3.
Use the same value in the dummy cell.
RNC ID (mcIdentity) RNC ID of the AC - this is selected by choosing the BSMIS object
for the AP’s site.
AC address (acAddressinUse) IP Address or FQDN of the serving AC.
MCC (mcc) Mobile Country Code.
MNC (mnc) Mobile Network Code.
LAC (lac) Location Area Code.
RAC (lac) Routing Area Code.
SAI SAC (sac) This is the SAI SAC (Service Access Code) which can be used by
the billing system. If this is not used by the billing system, it is
recommended to set this to 1.
SAI LAC (saiLac) SAI Location Area Code which can be used by the billing system.
This is a different value than the LAC set in the
lacRacCandidateList for an individual AP. If this is not used by the
billing system, it is recommended to set this to 1.
UARFCN within
(rfParamsCandidateList)
The frequency on which the AP will operate. This should be
determined by network planning.
Scrambling code
within (rfParamsCandidateList)
The scrambling code assigned to the AP. This should be
determined by network planning.
RSSI scan bands
(rssiScanBands_002)
Specify which bands to scan with Network Listen, when
performing RSSI detect and BCCH decode tests. Leave this empty
to scan all bands supported by the AP hardware.
Lat, Long and LCS uncertainty
(lcsLatitude), (lcsLongitude),
(lcsUncertainty)
Latitude and longitude of the APs installation site, for RANAP
location reporting