User's Manual

Table Of Contents
nano3G AP Installation Manual Pre-Provisioning a nano3G AP
N3G_INST_300 v292_1.0 for N3G_2.92 © ip.access Limited 2012 Page 35
3.2.4 Optional - Select an AP Template
13) If any templates of the correct object type are available, the Template Selection
page will appear:
Optionally use this page to load a template for the AP. Typically the template can
contain a reference configuration for the AP according to the AP’s intended
location and/or usage.
For information on working with templates, see [OPM_415].
14) To use a template, click the required template in the list, then click Next. If a
template is not required for this AP, click Next without selecting anything in the list.
3.2.5 Enter AP Identification Details
15) The page for specifying AP identification details will appear:
Notice that the 3G AC Name, Management Server Address and Security Gateway
are set automatically according to the BSMIS object selected for invoking the
wizard. The 3G AC Name and Management Server Address may not be changed.
16) Click in the Site ID box and type a numeric ID. This must be unique within the
parent AC object. As the ID number is entered, the Site Name is set automatically.
Note: Do not use the AP’s serial number for the Site ID or the HNB C-Id. An AP
can be physically replaced at a site, in which case the site configuration
will stay the same, but the AP’s serial number will be updated.