User's Manual
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 2.1 Installation Tasks
- 2.2 Requirements for All nano3G APs
- 2.2.1 General Requirements
- 2.2.2 nano3G AP Cooling
- 2.2.3 Information Required for Pre-Provisioning
- 2.2.4 Parameters for Enterprise Deployments
- 2.2.5 Parameters for Residential Deployments
- 2.2.6 Access Control
- 2.2.7 Closed Access with CSG Parameter Broadcast
- 2.2.8 Closed Access in Legacy Mode
- 2.2.9 Pre-Prepared Configurations - Optional
- 2.2.10 Information Required for Commissioning
- 2.2.11 Other Items for Commissioning
- 2.3 nano3G S8 AP Site Requirements
- 2.4 nano3G S16 AP Site Requirements
- 2.5 nano3G E8 AP and nano3G E16 AP Site Requirements
- 3 Pre-Provisioning a nano3G AP
- 4 Configuration File Preparation
- 5 Commission a nano3G AP
- 6 nano3G AP Hardware Installation
- 7 Finalize Installation
- 8 Troubleshooting
- 9 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual Installation Overview and Requirements
N3G_INST_300 v292_1.0 for N3G_2.92 © ip.access Limited 2012 Page 30
2.5.3 nano3G E8 AP IP Bandwidth Requirements
At maximum capacity and with IPsec in use, a nano3G E8 AP will require:
• Downlink: 17Mbps
• Uplink: 1.8Mbps
This will deliver up to 8 voice calls and HSDPA services up to 14.4 Mbps.
Note: If the available bandwidth on site does not meet the requirements see the Troubleshooting
section 8.
2.5.4 nano3G E16 AP IP Bandwidth Requirements
At maximum capacity and with IPsec in use, a nano3G E16 AP will require:
• Downlink: 17Mbps
• Uplink: 1.9Mbps
This will deliver up to 16 voice calls and HSDPA services up to 14.4 Mbps.
Note: If the available bandwidth on site does not meet the requirements see the Troubleshooting
section 8.
2.5.5 nano3G E8 AP and E16 AP Installation Tool Requirements
To mount the bracket onto the wall:
• 6 pan head screws, size No. 6 (approx 3.5mm (0.14in) in diameter) – 4 for the AP
bracket, 2 for the POE+ adapter
Note: No screws are supplied to mount the AP or the POE+ unit.
• Wall plugs if required.
• Suitable drills and screwdriver.
Note: If the available bandwidth on site does not meet the requirements see the Troubleshooting
section 8 N User Configuration.