User's Manual
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 3 Pre-Provisioning a nano3G AP
- 4 Configuration File Preparation
- 5 Commission a nano3G AP
- 6 nano3G AP Hardware Installation
- 7 Finalize Installation
- 8 Troubleshooting
- 9 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual Troubleshooting
N3G_INST_300 v14.0 for N3G_2.85 © ip.access Limited 2012 Page 75
1) Log into the NOS Client and find the AP. The user ID must have Full Access rights
to the AP.
Hence find, Root > APs > BSMIS APs Per AC > Site > relevant AP.
2) Select 3G AP Load Control Package from the Navigation Pane.
3) Select the attribute max Downlink Backhaul Bit Rate (Kbps) and set to the relevant
value.
4) Select the attribute max Uplink Backhaul Bit Rate (Kbps) and set to the relevant
value.
5) Click Apply to save changes.