User's Manual

nano3G AP Installation Manual Troubleshooting
N3G_INST_300 v14.0 for N3G_2.85 © ip.access Limited 2012 Page 70
8.1.2 nano3G S8 AP LEDs
The following table shows the meaning of the status LEDs under normal and fault
conditions.
Power Off The AP is not switched on.
Green The AP is powered up normally.
Flashing green Self-test is running.
Red There is a fault with the AP.
Ethernet
Link
Amber This is on to show the link is active, or flashes when there is network
activity.
Ethernet
Speed
Green Shows the network speed. On for 100Mbps or off for 10Mbps.
Power
Off The nano3G AP is not switched on.
Green The nano3G AP is powered up normally.
Flashing green Self-test is running.
Red There is a fault with the nano3G AP.
Network
Off Unable to detect a network. This is usually because there is no
network cable connected, or there is no network connection at the
other end of the cable (for example, the router or broadband modem
may have failed).
Green The 100Mbps connection is OK.
Flashing green Indicates activity on the network at 100Mbps speed (that is, the
nano3G AP is sending and/or receiving data across the LAN).
Amber The 10Mbps connection is OK.
Flashing amber Indicates activity on the network at 10Mbps speed (that is, the
nano3G AP is sending and/or receiving data across the LAN).
Service
Off The nano3G AP is not provisioned, it has no IP address. This may be
a temporary condition when the AP is switched on for the first time, or
after factory reset.
Green The nano3G AP is provisioned and unlocked, it is connected to the
AP and is providing service.
Flashing green
(evenly, slowly)
The nano3G AP is provisioned but has lost connection to the AC, for
example because the AC is not available or there is a DNS problem.
Flashing green
(evenly, fast)
The nano3G AP has been reinitialized (the reset button was pressed
but for less than 5 seconds).
Off, with a short
green blink every
3 seconds
The nano3G AP is administratively Locked.
Off, with short
green blinks on
Factory reset is in progress in the nano3G AP (the reset button was
pressed for more than 5 seconds).
On, with short
green blinks off
Software download is in progress to the nano3G AP.