User's Manual
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 3 Pre-Provisioning a nano3G AP
- 4 Configuration File Preparation
- 5 Commission a nano3G AP
- 6 nano3G AP Hardware Installation
- 7 Finalize Installation
- 8 Troubleshooting
- 9 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual nano3G AP Hardware Installation
N3G_INST_300 v14.0 for N3G_2.85 © ip.access Limited 2012 Page 49
6 nano3G AP Hardware Installation
This section documents the procedures for installing the nano3G AP hardware and physical
connections.
The following hardware variants are described:
• 6.2 nano3G S8 AP Hardware Installation
• 6.3 nano3G E8 AP and E16 AP Hardware Installation
Note: If possible, the engineer should stay on site until the AP is brought into service, ready to
make test calls to verify the AP has been configured correctly from the NOS.
Note: For residential deployments where an AP is installed by an end-user following an easy
setup guide, ignore all of section 6.
6.1 Warnings and Regulatory Information
For all warnings and regulatory information, see section 9.