User's Manual

nano3G AP Installation Manual Contents
N3G_INST_300 v14.0 for N3G_2.85 © ip.access Limited 2012 Page i
Table of Contents
1 Introduction............................................................................................1
1.1 Overview ............................................................................................................ 1
1.2 User Requirements ............................................................................................ 1
1.3 Related Information............................................................................................ 2
1.4 Licenses and Copyright Notices ........................................................................ 2
1.5 Terminology ....................................................................................................... 2
2 Installation Overview and Requirements ............................................3
2.1 Installation Tasks ............................................................................................... 3
2.1.1 Pre-Provisioning ................................................................................................... 3
2.1.2 Commissioning..................................................................................................... 3
2.1.3 On Site Installation ............................................................................................... 4
2.2 Requirements for All nano3G APs ..................................................................... 4
2.2.1 General Requirements ......................................................................................... 4
2.2.2 nano3G AP Cooling.............................................................................................. 5
2.2.3 Information Required for Pre-Provisioning ........................................................... 6
2.2.4 Pre-Prepared Configurations - Optional ............................................................. 10
2.2.5 Information Required for Commissioning ........................................................... 11
2.2.6 Other Items for Commissioning.......................................................................... 12
2.3 nano3G S8 AP Site Requirements .................................................................. 13
2.3.1 nano3G S8 AP Power Requirements................................................................. 13
2.3.2 nano3G S8 AP Physical Requirements.............................................................. 15
2.3.3 nano3G S8 AP IP Bandwidth Requirements...................................................... 16
2.3.4 nano3G S8 AP Sundry Installation Equipment................................................... 16
2.4 nano3G E8 AP and nano3G E16 AP Site Requirements ................................ 17
2.4.1 nano3G E8 AP and E16 AP Power Requirements............................................. 17
2.4.2 nano3G E8 AP and E16 AP Physical Requirements ......................................... 18
2.4.3 nano3G E8 AP IP Bandwidth Requirements...................................................... 19
2.4.4 nano3G E16 AP IP Bandwidth Requirements.................................................... 19
2.4.5 nano3G E8 AP and E16 AP Installation Tool Requirements.............................. 19
3 Pre-Provisioning a nano3G AP........................................................... 20
3.1 Create a Site for a New AP.............................................................................. 20
3.1.1 Start the Create Site Wizard............................................................................... 20
3.1.2 Optional - Use an Existing AP Configuration...................................................... 21
3.1.3 Optional - File Selection ..................................................................................... 22
3.1.4 Optional - Select an AP Template ...................................................................... 24
3.1.5 Enter AP Identification Details............................................................................ 25
3.1.6 Select NTP Servers............................................................................................ 26
3.1.7 Modify NAS and Network Listen Settings........................................................... 26
3.2 Apply an Attribute Configuration to the AP ...................................................... 30
3.2.1 Load a Configuration File for the AP .................................................................. 30
3.2.2 Apply an AP Template to the AP........................................................................ 31