User's Manual
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 3 Pre-Provisioning a nano3G AP
- 4 Configuration File Preparation
- 5 Commission a nano3G AP
- 6 nano3G AP Hardware Installation
- 7 Finalize Installation
- 8 Troubleshooting
- 9 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual Pre-Provisioning a nano3G AP
N3G_INST_300 v14.0 for N3G_2.85 © ip.access Limited 2012 Page 27
29) Enter a valid LAC/RAC combination that this AP can use, according to network
planning for this AP. For example:
Multiple RACs can be configured for each LAC. At least one LAC/RAC
combination must be provided.
30) Select the RF Parameters Candidate List.