User's Manual

nano3G AP Installation Manual Pre-Provisioning a nano3G AP
N3G_INST_300 v14.0 for N3G_2.85 © ip.access Limited 2012 Page 26
27) Click the Network Listen Control Package:
The number of entries within the lists in Network Listen Control Package will
depend on how the AP is configured:
• Static configuration: If an AP will have a planned static configuration, enter
only one set of values for each list. That is, one LAC-RAC combination and
one set of RF Parameters. This is typically the scenario for enterprise
deployments where the parameters have been determined by network
planning.
• Dynamic configuration: If an AP will use Network Listen results to
automatically select its parameter settings, in an attempt to choose optimal
settings for its detected RF environment, enter multiple sets of values for
each list. That is, multiple LAC-RAC combinations and multiple sets of RF
Parameters. This is typically the scenario for domestic plug-and-play or
SOHO deployments. Also, in this scenario, it is expected that an existing AP,
template or file will have been selected which has pre-configured lists. If this
is not the case, it may be more efficient to enter a single set of parameters in
the wizard, and then either configure the AP object directly or load
pre-configured lists against the AP object.
28) If the LAC/RAC entries are invalid, as in the example, drill down into the LAC -
RAC Candidate List to find the invalid entry: