User's Manual
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 3 Pre-Provisioning a nano3G AP
- 4 Configuration File Preparation
- 5 Commission a nano3G AP
- 6 nano3G AP Hardware Installation
- 7 Finalize Installation
- 8 Troubleshooting
- 9 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual Pre-Provisioning a nano3G AP
N3G_INST_300 v14.0 for N3G_2.85 © ip.access Limited 2012 Page 20
4) Select the Object Class radio button and in the drop-down list on the left ensure
Nano-8 or Nano-16 3G AP (SR2.0 -) is selected. This is applicable to E8 APs, E16
APs and S8 APs.
Note: Do not select Nano-4 3G AP (SR2.0 -) as this is not supported in
N3G_2.85.
Note: If they are present, do not choose either of the choices for (SR1.2 -
PRE-SR2.0). These are only used for APs running software from a
release prior to N3G_2.85. These choices must be present for backwards
compatibility and they enable AP upgrades from previous releases.
3.2.2 Optional - Use an Existing AP Configuration
5) Click Next and the AP Selection page of the wizard will appear:
Optionally use this page to copy the configuration of an existing AP.