User's Manual
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 3 Pre-Provisioning a nano3G AP
- 4 Configuration File Preparation
- 5 Commission a nano3G AP
- 6 nano3G AP Hardware Installation
- 7 Finalize Installation
- 8 Troubleshooting
- 9 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual Installation Overview and Requirements
N3G_INST_300 v14.0 for N3G_2.85 © ip.access Limited 2012 Page 15
2.3.3 nano3G S8 AP IP Bandwidth Requirements
At maximum capacity, a nano3G S8 AP will require:
• Downlink: 17Mbps
• Uplink: 1.8Mbps
This will deliver up to 8 voice calls and HSDPA services up to 14.4 Mbps.
Note: If the available bandwidth on site does not meet the requirements see the Troubleshooting
section N User Configuration8.
2.3.4 nano3G S8 AP Sundry Installation Equipment
To mount the POE splitter or the nano3G S8 AP onto the wall:
• 2 self tapping pan head screws, size No. 6 (approx 3.5mm (0.14in) in diameter)
• Wall plugs if required
• Suitable drills and screwdriver
Note: If the available bandwidth on site does not meet the requirements see the Troubleshooting
section N User Configuration8.