Operating Guide
Table Of Contents
- nano3GAP Operations Manual
- 1 Introduction
- 2 Common Procedures
- 3 Troubleshooting the nano3GAP
nano3GAP Operations Manual Troubleshooting the nano3GAP
© ip.access Ltd Page 17
3.5 Factory Reset
Factory reset can be used when there are no ways to repair the AP-AC connection. The
AP configuration needs to be redone manually after the factory reset, see [INST_300].
To perform factory reset, press the fa
ctory reset button and hold it for more than 5
seconds.
When the button is initially pressed, the LED will blink fast (50ms on:50ms off) for 5
seconds, then it will start to blink slowly (200ms on: 200ms off). When the factory restore
process has completed, the LED will extinguish and the AP will automatically reboot, take
the fixed IP address and enable the web interface for configuration section 3.3.2.