Operating Guide

nano3GAP Operations Manual Troubleshooting the nano3GAP
© ip.access Ltd Page 13
3 Troubleshooting the nano3GAP
3.1 Monitoring Alarms from the nano3GAP
For instructions see [OPM_410]. For information on the alarms, see [REF_130].
3.2 Modifying the AP Configuration
3.2.1 Create an Attribute Configuration File for an AP
The properties of the AP can be set from the OMC-R. Optionally, attributes can be
imported from a text file.
For the description of the text file format and for instructions on how to use it, see
[INST_300].
3.2.2 Download the Attribute Configuration File to the AP
For instructions, see [INST_300].
3.3 Modifying the AP-AC Connection
The configuration of a nano3GAP can be modified in a web interface from the provisioning
PC. The AP-AC connection and the IP configuration of the AP can be managed this way.
The web interface is only enabled by default during commissioning when the AP is in
factory reset state. To enable the web interface, the nano3GAP needs to be put into
factory reset state (see section 3.5).
1)
Start a web browser and go to the following address:
http://192.168.0.1:8089/
2) Enter the username and password.
3.3.1 Modify the Connection to the AP
For instructions, see [INST_300].
3.3.2 Edit the IP Configuration of the AP
For instructions, see [INST_300].