Operating Guide

nano3GAP Operations Manual Common Procedures
© ip.access Ltd Page 8
Report
Diagnostics Now
The AP will report its current log files to the URL contained in the action.
Perform
Software
Download
The AP will download the new software image from a specified URL.
The optional attribute swDownloadOps controls what operations the AP
performs following the download; this can be used to change the default
SW version of the AP and to reboot it. If this parameter is not present,
then the AP performs the download and changes the default SW
version, but does not reboot.
Swap Default
Software
The AP will change its default software version, that is, the software that
will be run the next time the AP reboots.
The attribute defaultSwVersion in the AP Admin package, which reports
the current default software version, will change when the Swap Default
Software action is completed.
Report
Measurements
The AP wil send a measurement report, as set up in the Measurement
Control package. The component behaviour on receiving this action is
similar to the component behaviour for Periodic Measurement
Reporting. The key difference is that the periodic timers are left
unchanged while the time of the next scheduled report remains the
same.
Abort Network
Listen Test
Stops all Network Listen activities and resets the value of the attribute
nwlTestStatus to "NWL_IDLE".
Apply Frequency
Correction
Uses the results of the most recent BCCH Detect test to adjust the
crystal oscillator of the AP. When the adjustment is done, the value of
the attribute estimatedFreqOffset is set to zero.
Frequency correction is not possible if either the value of the attribute
estimatedFreqOffset is zero or the BCCH Detect results are older than
one hour.
Factory Restore Restores the AP settings to their factory defaults and triggers a
reinitialization.
Start BCCH
Detect Test
Invokes the BCCH Detect Test that performs an RSSI scan followed by
an attempt to decode BCCH (GSM) and CPICH (UMTS) for each
ARFCN or UARFCN that has an RSSI value above the associated
decode threshold.
Note: This test is recommended only as part of a diagnostic
procedure.
Start RSSI Scan
Test
Invokes the RSSI Scan Test that scans the enabled bands and
ARFCNs.
Note: This test is recommended only as part of a diagnostic
procedure.
Start Sequential
NWL Tests
Invokes a sequence of Network Listen tests: RSSI scan, BCCH Detect
Test and Frequency Accuracy Test. The order of the tests is identical to
that of a scheduled NWL test.