Installation Guide
Table Of Contents
- nano3GAP Installation Manual
- 1 Introduction
- 2 Installation Requirements
- 3 nano3GAP Hardware Installation
- 4 Deployment Commissioning of the nano3GAP
- 5 Configuration of the nano3GAP-4 from the OMC-R
- 6 Troubleshooting
- 7 nano3GAP and PSU Regulatory Information
- 8 Appendices
- 8.1 Appendix A - Example AP Configuration File
- 8.2 Appendix B - Licenses and Copyright Notices
- 8.2.1 asn1c
- 8.2.2 bash
- 8.2.3 BusyBox
- 8.2.4 cramfs
- 8.2.5 dropbear
- 8.2.6 glibc
- 8.2.7 gmp
- 8.2.8 ipkg
- 8.2.9 iproute2
- 8.2.10 iptables
- 8.2.11 libcurl
- 8.2.12 libgcc
- 8.2.13 libpcap
- 8.2.14 libxml2
- 8.2.15 Linux Kernel
- 8.2.16 mtd.utils
- 8.2.17 ncurses
- 8.2.18 NTP daemon
- 8.2.19 pcre
- 8.2.20 procps
- 8.2.21 SSL Stack
- 8.2.22 StrongSwan
- 8.2.23 TCL
- 8.2.24 tcpdump
- 8.2.25 thttpd
- 8.2.26 U-Boot
- 8.2.27 zlib
- 8.2.28 General Licenses
nano3GAP Installation Manual Installation Requirements
© ip.access Ltd Page 7
o JavaScript enabled in the web browser
2.3 Information Needed for Installation
2.3.1 Network Information
Installation Engineer:
• subnet information: the installation laptop and the nano3GAP-4 to be configured
must be on the same subnet
• username and password for the AP web server
• address of the security gateway
• address of the serving 3G AC
• ID of this AP on the serving 3G AC
• CRL and NTP server addresses
• DHCP or static IP
• if IPSec is used: Traffic Selector information (IP address and subnet mask)
NOC Engineer:
• Username and password to the OMC-R
• The valid URL to the latest AP software image on the OAM File Server
• Configuration file to be used in the OMC-R Load Attributes Wizard (nano3GAP-4s
hold the master copy of their own configuration and are not pre-provisioned via
the OMC-R)
• Configuration data for the AP:
o MCC
o MNC
o LAC
o SAI
o SAC/LAC
o UARFCN
o Scrambling code
o RNC ID
o RAC
2.3.2 AP Configuration File
Create a separate attributes file for each AP to commission (section 5.3).