User's Manual

nano3G AP Installation Manual Configuring a nano3G AP from the OMC-R
N3G_INST_300 v6.3 for N3G_2.0 © ip.access Limited 2010 Page 39
2) Right-click the AP, select Actions and then Perform Software Download. The
Perform Software Download Actions dialogue box will appear.
3) Change the SW Download Operations to Download, Swap and Reboot.
4) Click in the SW Image Download URL box and enter the URL of the required SDP
file using the following URL pattern:
http://<server>/download/sw/<filename>.sdp
Where <server> is the IP address or host name of the required OAM File Server,
and <filename>.sdp is the required software download package file.
5) Press <TAB> or <Enter> to set the URL.
6) Click Finish and the download will take place. On the AP, download progress is
indicated by the flashing network LED. When the download is complete, the AP will
reboot under the new software, which should take less than 1 minute.
7) Wait for the AP to be shown as connected to the OMC-R.
8) Select the 3G AP Admin Package for the AP object and verify that the Filesys
version reported by the Active Software Version matches the SDP file that was
downloaded.
6.2 Apply an Attribute Configuration to the AP
1) Ensure the attribute configuration file is available on the OMC-R Server or the
computer running the OMC-R Client. For information on preparing an AP
configuration file, see section 5.
2) Log in to the OMC-R Client with a user name that has Full Access to the AP.
3) To start the OMC-R Load Attributes Wizard, right-click on the AP object in the
OMC-R Client and then select Load Attributes From File.
4) Browse to the edited configuration file and click Apply to load and apply the
configuration settings.
If any of the loaded values are inconsistent with the current state of the AP or if any
of the values are illegal, the wizard displays a warning.
5) Repeat as needed, if there are multiple configuration files.