User's Manual

nano3G AP Installation Manual Configuring a nano3G AP from the OMC-R
N3G_INST_300 v6.3 for N3G_2.0 © ip.access Limited 2010 Page 38
6 Configuring a nano3G AP from the OMC-R
The nano3G AP needs to be configured before it is brought into service. All the remaining
configuration changes must be applied via the OMC-R Client, typically by a NOC engineer.
6.1 Check and Upgrade the nano3G AP Software Image
6.1.1 Check the Current Software Image Version
1) Login to the OMC-R Client with a user name (and password) that has Full Access
rights for changing the AP's configuration.
2) Find the AP according to its serial number and select the AP object.
Note: For full information on using the OMC-R Client, see [OPM_410].
3) Verify that the AP Connection has a green tick, to show that the AP is connected
to the AC. The AP object, below the AP Connection, is currently locked. The AP
will remain locked until it is properly configured and ready to provide service.
4) In the Navigation pane, browse to the AP Admin Package.
5) Check the values of the Active SW Version and Standby SW Version attributes.
6) If the AP does not have the latest software image, download it to the AP from the
OAM File Server according to the instructions below.
6.1.2 Download the Latest Software Image from the OAM File Server to
the AP
For instructions about how the software images (SDP files) are uploaded to the OAM File
Server, see [OPM_430].
1) Select the AP in the OMC-R Client.