User's Manual
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Requirements
- 3 nano3G AP Hardware Installation
- 4 Commission a nano3G AP
- 5 Configuration File Preparation
- 6 Configuring a nano3G AP from the OMC-R
- 7 Troubleshooting
- 8 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual nano3G AP Hardware Installation
N3G_INST_300 v6.3 for N3G_2.0 © ip.access Limited 2010 Page 17
Mount the nano3G S4 AP on a Stand
1) Plug the Ethernet cable and the power cable into the AP or plug the cables from
the POE splitter into the AP.
2) Slide the AP onto the stand.
3) Place the AP on its stand on a stable flat surface.