User's Manual
Table Of Contents
- nano3G AP Installation Manual
- Table of Contents
- 1 Introduction
- 2 Installation Requirements
- 3 nano3G AP Hardware Installation
- 4 Commission a nano3G AP
- 5 Configuration File Preparation
- 6 Configuring a nano3G AP from the OMC-R
- 7 Troubleshooting
- 8 nano3G AP and PSU Regulatory Information
nano3G AP Installation Manual Installation Requirements
N3G_INST_300 v6.3 for N3G_2.0 © ip.access Limited 2010 Page 13
2.4.3 IP Bandwidth Requirements
At maximum capacity, a nano3G E8 AP will require:
• Downlink: at least 7Mbps
• Uplink: at least 1Mbps
This will deliver up to 8 voice calls and HSDPA services up to 7.2 Mbps.
Note: The HSDPA rate of 7.2Mbps is the air-interface rate on Uu. The downlink rate needed to
support this is lower. The uplink assumes a maximum load of 8 UEs each with 64Kbps PS
bearers. Voice traffic has negligible impact.
2.4.4 Installation Tool Requirements
• To mount the bracket onto the wall:
• 6 pan head screws, size No. 6 (approx 3.5mm (0.14in) in diameter) – 4 for
the nano3G E8 AP, 2 for the POE+ adapter
Note: No screws are supplied to mount the AP or the POE+ unit.
• Wall plugs if required.
• Suitable drills and screwdriver.