User's Manual

nano3G AP Installation Manual Installation Requirements
N3G_INST_300 v6.3 for N3G_2.0 © ip.access Limited 2010 Page 6
The following ports are also used. When IPsec is used, they may be inside or outside the
IPSec tunnel, depending on configuration:
2.2.2 Information Required for Commissioning
All nano3G AP models require the configuration details listed in this section. This
information will typically be used on-site to commission an AP from the provisioning laptop,
so that the AP can subsequently connect to its serving AC.
Note: It is possible to commission an AP before taking it on site. However, this means that the Cell
ID for the AP must be known and correctly configured before it is taken on site, as the Cell
ID is one of the initial commissioning parameters.
For connecting to the AP from the provisioning laptop:
• User name and password for the AP web server - contact customer support at
ip.access for the current user name and password
For commissioning the AP:
• IP Address or FQDN of the serving nano3G AC
• Cell ID (also used as the ID of this AP on the serving nano3G AC)
• IP Address or FQDN of an NTP server
• DHCP or static IP
• If static IP is required:
• IP address for the AP
•Netmask
• IP Address or FQDN of the default gateway
• IP Address or FQDN of the Primary DNS
• IPSec is optional, but if IPSec is required:
• IP Address or FQDN of the IPsec Security Gateway
• IP Address or FQDN of a CRL server
udp 5002 PS Mux to AC
Protocol Destination Port Use
tcp 80 PM upload, software download, CRL download
tcp 443 PM upload, software download, CRL download
udp 53 DNS
udp 67 DHCP - not needed for static IP configuration
udp 68 DHCP - not needed for static IP configuration
udp 123 NTP
Protocol Destination Port Use