Users Manual

ITM-1066A User Manual
Proprietary & Confidential Information iotTech Corporation, Taiwan
Doc. NO:
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following" Contains FCC ID: 2AWP5WM1066A ".
2.9 Information on test modes and additional testing requirements
Host manufacturer which install this modular with limit modular approval should perform the test of radiated emission
and spurious emission according to FCC part 15 :15.247 and 15.407 requirement, only if the test result comply with
FCC part 15.247 and 15.407 requirement, then the host can be sold legally.
When testing host product, the host manufacture should follow FCC KDB Publication 996369 D04 Module Integration
Guide for testing the host products. The host manufacturer may operate their product during the measurements.
2.10 Additional testing, Part 15 Subpart B disclaimer
Host manufacturer is responsible for compliance of the host system with module installed with all other applicable
requirements for the system such as Part 15 B.

CAUTION:
Anychangesormodificationsnotexpresslyapprovedbythegranteeofthisdevicecouldvoidtheuser'sauthority
tooperatetheequipment.
RFExposureWarning
Thisequipmentmustbeinstalledandoperatedinaccordancewithprovidedinstructionsandtheantenna(s)used
forthistransmittermustbeinstalledtoprovideaseparationdistanceofatleast20cmfromallpersonsandmust
notbeco‐locatedoroperatinginconjunctionwithanyotherantennaortransmitter.
End‐usersandinstallers
mustbeprovidewithantennainstallationinstructionsandtransmitteroperatingconditionsforsatisfyingRF
exposurecompliance.

EndProductLabeling
Thistransmittermoduleisauthorizedonlyforuseindevicewherethe antennamaybeinstalledsuchthat20cm
maybemaintainedbetweentheantennaandusers.Thefinalendproductmustbelabeledinavisi bleareawith
thefollowing:"ContainsFCCID:2AWP5WM1066A”
InformationfortheOEMsandIntegrators
Thefollowingstatementmustbeincludedwithallversionsofthisdocumentsuppliedtoan
OEMorintegrator,butshouldnotbedistributedtotheenduser.
1)ThisdeviceisintendedforOEMintegratorsonly.
2)PleaseseethefullGrantofEquipmentdocumentforotherrestrictions.